Doh!

[Jono]

For custom made hoses I use....

http://www.lister.co.uk/ecommerce/re...act=FRAMESETUP

[BluFin]

Well if I got it right you should be able to print the two attached at 100% scale and have a layover chart to compare against

[Matt]

Cool!

Did you take a look at the pics I sent ya?

[Jono]

Originally Posted by BluFin

Well if I got it right you should be able to print the two attached at 100% scale and have a layover chart to compare against

Yeah....but... it still says 20TPI and Matt says 24TPI..or has Mr Matt lost the ability to count?

[Matt]

Nah, I double checked and everything.

The thread on a trim pump is 7/16x24.
The thread on trim hoses is either 3/8x24 or 7/16x24 depending on the application.

For 3/8 hoses, there's a brass adaptor that screws into the trim pump.

They're all 37 degree double lipped inverted jobbes. (So not JIC, NPTF etc)

[BluFin]

Originally Posted by Matt

Cool!

Did you take a look at the pics I sent ya?

Yep Pm me a valid email as one to webmaster@threadmaster.com bounces back, bit of info if I get time tomorrow


RTFQ BluFin thought Matt wanted a 7/16 20tpi Dolt !!!!!!

[Matt]

Nah, I was asking for your thoughts on Project X

[BluFin]

Thats what I mean reply was too big for a PM

[Matt]

Oh, OK. Try a mail to nospam, thanks