xr2 low water psi

[Wayne Kerr]

To be honest James, I never found out why the pumps melted and I can't remember which plate was fitted. I can confirm that an xr2 tuner was (and still is) used.
All I done was to change the box an all works well now.
The CLE is sitting in the garage to this day, just to remind me of the struggle it gave me.

[Jamesalan]

Originally Posted by M.arco

I once replaced an impeller and forgot there was still a rubber on the tube (going into the mid). I placed a new rubber on the impellerhousing so there were 2. The PSI was very low and the engine was running hot!!

Sorry for late reply, pulled everything back apart and plugged the triangle dump hole in the top plate, checked water pump and put it back together.. Finally water pressure out both tell tales! will report on psi and temp when I have give it a run on the water!

James

[Jamesalan]

Originally Posted by Wayne Kerr

To be honest James, I never found out why the pumps melted and I can't remember which plate was fitted. I can confirm that an xr2 tuner was (and still is) used.
All I done was to change the box an all works well now.
The CLE is sitting in the garage to this day, just to remind me of the struggle it gave me.

Cheers Wayne! You need that CLE hung up on your living room wall to remind you!

James

[Cream Marine]

have you checked the poppet valve? if the spring or the seal goes it just goes straight through. before taking it apart put your finger over the starboard side tell tail and see if the velocity and quantity of the port telltale increases. if so then poppet valve/ or spring knackered.

[Jamesalan]

Originally Posted by Cream Marine

have you checked the poppet valve? if the spring or the seal goes it just goes straight through. before taking it apart put your finger over the starboard side tell tail and see if the velocity and quantity of the port telltale increases. if so then poppet valve/ or spring knackered.

I haven't checked that, I will check it out over the weekend and see if it's okay.
Cheers!
James

[sinkunit0]

It's not got a poppet valve

[Jamesalan]

Originally Posted by sinkunit0

It's not got a poppet valve

Yeah forgot about that oups

[Jamesalan]

Will this one piece tuner run okay with the XR2 200? Think the exhaust holes look different sizes, will this effect the performance?

James