Merc 2.0/2.4/2.5 EFI stuff wanted

beyondhelp · 03-09-2013, 09:08 PM

I'm after if possible a complete EFI setup from a 2.0/2.4/2.5 (may not exist on a 2.0??) I believe I need the reed block/inlet/throttle bodies/injectors/and cover etc.. Its to go on a 2.0 or possibly a 2.4, undecided as yet.

I don't need any harnesses/looms/or ECU/VST etc etc, or even injectors for that matter but would make life easier.

Someone must have some stuff lying about from a blown engine?

Please PM me if you do if your not asking silly money. Its to be used as an experiment. Just interested to see what a merc 2 stroke runs like on modern engine management.

grandmas denture · 03-09-2013, 10:47 PM

... dyou prefer 1 or 4 throttle system ?

Techteam · 03-09-2013, 10:54 PM

Quote:

Originally Posted by beyondhelp

Just interested to see what a merc 2 stroke runs like on modern engine management.

Very Well

Of course you'd have to change the Crankcase for a standard EFI setup if your thinking SST as 14 finger reeds.

You could adapt a MAD EFI which mounts the injectors differently.

Lazer type Injection is an easier conversion but hardly worth the bother.

If you want to play, it's a lot of work but I'd buy a complete electrics cast off from a 280 and swap out the Motorola ECU

Hydrostream · 03-09-2013, 11:15 PM

I probably have these bits!
Will need a block half as techteam has said unless you find another way to mount injectors! Often thought about putting them in an intake spacer plate.

beyondhelp · 03-09-2013, 11:27 PM

TBH I'm not too familiar at all on the different arrangements, hence the other post asking questions.

I agree its a little bit of a project. Providing things bolt on it wont take me long to get it running.

grandmas denture; I don't have experience of either really. Provided it works, I'm not fussed. You have given me another thought now that if a plenum can be made with single throttle body (I think I've seen these) then that would make my life easier as I'd fit a DBW (drive by wire) throttle to it. Would need to think about how to mount the injectors, but I quite like the idea of that.

Hydrostream · 03-09-2013, 11:44 PM

You could try find a downdraft snout off a 2.5 X motor, they house the injectors inside the plenum like a laser setup but much better air flow.

beyondhelp · 02-01-2014, 02:02 AM

Still not had any luck with this.

Still interested if anyone has anything (at sensible prices)

robj1980 · 03-01-2014, 10:29 PM

hi give me a call should have what u need 07769977198