Forum: Technical Q&A
25-01-2007, 07:53 PM
|
Replies: 23
Views: 2,523
|
Forum: Technical Q&A
24-01-2007, 03:58 PM
|
Replies: 23
Views: 2,523
|
Forum: Technical Q&A
24-01-2007, 03:57 PM
|
Replies: 23
Views: 2,523
Hi Byrtu, I thought the movement was in the...
Hi Byrtu, I thought the movement was in the bushes, as I read a lot about it, in different threads. When I got the mid off, it was obvious that the play was in the bottom yoke. I tried the lock seal...
|
Forum: Technical Q&A
24-01-2007, 01:50 PM
|
Replies: 23
Views: 2,523
|
Forum: Technical Q&A
24-01-2007, 01:47 PM
|
Replies: 23
Views: 2,523
|
Forum: Technical Q&A
24-01-2007, 01:46 PM
|
Replies: 23
Views: 2,523
|
Forum: Technical Q&A
24-01-2007, 01:45 PM
|
Replies: 23
Views: 2,523
|
Forum: Technical Q&A
24-01-2007, 12:14 PM
|
Replies: 23
Views: 2,523
Swivel bracket and steering ar
Hi all, Stripped steering arm off, to replace bushes, as it had movement. I've found the bushes to be ok but there is a problem with the bottom yoke. It doesn't appear to be worn, nor does the...
|
Forum: Technical Q&A
20-01-2007, 07:29 PM
|
Replies: 23
Views: 2,523
Hi again Brian, Just measured it exactly. When...
Hi again Brian, Just measured it exactly. When bolted up, the point of the bullet will be 8cm / 3.1/8" below the hull. The lowest hole in the water intakes will be just above the bottom of the hull....
|
Forum: Technical Q&A
20-01-2007, 06:44 PM
|
Replies: 23
Views: 2,523
|
Forum: Technical Q&A
20-01-2007, 05:37 PM
|
Replies: 23
Views: 2,523
Hi All, Just when it looked like it was going...
Hi All, Just when it looked like it was going good.
Took power head off today, stripped gearbox from mid and mid from saddle. Fitted 20" mid to saddle. Got all the exhaust box, mountings and...
|
Forum: Technical Q&A
18-01-2007, 10:01 AM
|
Replies: 23
Views: 2,523
|
Forum: Technical Q&A
17-01-2007, 09:22 PM
|
Replies: 23
Views: 2,523
|
Forum: Technical Q&A
17-01-2007, 09:04 PM
|
Replies: 23
Views: 2,523
Change shaft or replace case
Mid arrived in Mallorca today, will collect it tomorrow. Looking at the manual, for changing the drive shaft. Not a simple job, specially without correct tools. Have been told it's a two hour job, by...
|