Forum: Technical Q&A
19-06-2010, 02:27 PM
|
Replies: 27
Views: 3,886
|
Forum: Technical Q&A
19-06-2010, 02:15 PM
|
Replies: 27
Views: 3,886
Laying up with epoxy resin
I am laying up my engine bay with epoxy resin (Reactive Resins, Sintac Standard resin) What is the maximum time allowed between layups to prevent delamanating in use or does it not really matter if...
|
Forum: Technical Q&A
18-06-2010, 01:37 AM
|
Replies: 27
Views: 3,886
Hmmmm, went away and had a re think after your...
Hmmmm, went away and had a re think after your comments gained from your years of experiance and have now come up with the following solution.
As the foam bearer's are quite high and the engine...
|
Forum: Technical Q&A
17-03-2010, 07:32 PM
|
Replies: 27
Views: 3,886
Drive plate
Wish I had known about the Steyr's reduced diameter plate, as it would have been better to use an of the shelf item that didn't need to be modified to fit. Is this a Steyr or Merc part ?
|
Forum: Technical Q&A
17-03-2010, 12:16 PM
|
Replies: 27
Views: 3,886
|
Forum: Technical Q&A
16-03-2010, 05:06 PM
|
Replies: 27
Views: 3,886
I am actually amazed that you bent 3/4 bolts,...
I am actually amazed that you bent 3/4 bolts, that really takes some doing.
Hmmm, that a worrying though a loose engine. The studs were actually hex head bolts with the heads turned down but in...
|
Forum: Technical Q&A
16-03-2010, 02:06 PM
|
Replies: 27
Views: 3,886
Stud size
Hi Jon and thanks for your replies
The vertical stud is 16mm, the horizontal bolt is 16mm shoulder bolt. The O/D of the polyurethane bush load bearing surface is 60mm. There is also a 24mm...
|
Forum: Technical Q&A
16-03-2010, 01:04 PM
|
Replies: 27
Views: 3,886
|
Forum: Technical Q&A
16-03-2010, 12:10 AM
|
Replies: 27
Views: 3,886
Help and advise wanted on foam engine bearers
Hi, I am converting a 225 Honda Cougar from out board to inboard engine. The stringers and bearers are foam cored. I do not really want to take them out and replace them with wood, I would like to...
|