Arneson ASD 8 Drive (Single) RH on this 32 Cougar Thunderboat
My understanding is this was only raced 6 or 7 times with a Sterling 750?
(boat is not for sale, just the Arneson set up)
Came with 19 Tooth Spline, for small shaft SSM #4 & #5 propellers or Rolla?
Also have an additional Shaft for it to allow you to run SSM #6 Propellers.
Has a Billet Machined case, machined by Zeiger Industries...eventually Arneson went to a cast case.
Currently has a 1.5 Gear ratio in the Billet Case, you can change gears to your desired ratio.
Comes with everything you see on the transom:
ASD #8 Arneson RH
Trim Cylinder
Steering Cylinder
All transom mounting hardware
Both Prop Shaft's
Twin skeg rudder
Buyer provides local pick up or the cost of shipping it
from USA / Muskegon Michigan 49442
Asking $15,000 / open to offers
My understanding is this was only raced 6 or 7 times with a Sterling 750?
(boat is not for sale, just the Arneson set up)
Came with 19 Tooth Spline, for small shaft SSM #4 & #5 propellers or Rolla?
Also have an additional Shaft for it to allow you to run SSM #6 Propellers.
Has a Billet Machined case, machined by Zeiger Industries...eventually Arneson went to a cast case.
Currently has a 1.5 Gear ratio in the Billet Case, you can change gears to your desired ratio.
Comes with everything you see on the transom:
ASD #8 Arneson RH
Trim Cylinder
Steering Cylinder
All transom mounting hardware
Both Prop Shaft's
Twin skeg rudder
Buyer provides local pick up or the cost of shipping it
from USA / Muskegon Michigan 49442
Asking $15,000 / open to offers
Attachments
Last edited:
