Holden Ss Ute 600hp Anyone?

[peter unwin]

CAPA HIGH PERFORMANCE TRUCK BASED ON HOLDEN SS UTE

THIS IS A VERY SPECIAL ONE OFF PICK UP TRUCK

REGISTERED SEPT 2003

20,000 KILOMETERS

FULL SPECIAL LEATHER INTERIOR
AIR CON/CLIMATE CONTROL ETC

5.7 SUPERCHARGED V8 CHEVY SMALL BLOCK WITH STEEL CRANK, STEEL RODS, FORGED PISTONS BIG VALVE HEADS , VORTEC RACING SUPERCHARGER, INTERCOOLED ,REWORKED ENGINE MANAGEMENT SYSTEM, LARGE FUEL INJECTORS WITH WITH VARIABLE FUEL PRESSURE( BOOST DEPENDENT)

POWER 600HP TORQUE 900Nm

MATED TO 6 SPEED MANUAL TRANSMISSION WITH TWIN PLATE RACING CLUTCH, TRANSMISSION OIL COOLER

LSD DIFFERENTIAL WITH PRELOAD , DIFFERENTIAL OIL COOLER

AP RACING 6 POT CALIPERS WITH 380mm DISCS ON FRONT
AP RACING 4 POT CALIPERS WITH 350mm DISCS ON REAR

CAPA AERODYNAMIC BODY KIT WITH CARBONFIBRE UNDERTRAY
FULLY ADJUSTABLE DAMPERS FRONT AND REAR
FULLY ADJUSTABLE ANTI ROLL BARS FRONT AND REAR
19” WHEELS WITH 245/35ZR19 GOODYEAR EAGLE F1 TYRES

IMPORTANT NOTE-THIS VEHICLE IS NOT FITTED WITH DRIVER AIDS![/B]

VEHICLE CAN BE VIEWED MON-THURSDAY MOIRA DE12 6AL ,
OR FRIDAY - SUNDAY HAMBLE LE RICE

INTERESTED PARTIES CONTACT PETER UNWIN

EMAIL PETER@UNWINHYDRAULIC.CO.UK

NO TEST PILOTS PLEASE
PRICE £22500+VAT

 

[225]

would make an awsome tow truck

 

[the bandit]

would make an awsome tow truck

With suspension like that i can't see how

 

[225]

fit bigger shock absorbers then, or just pull a very small boat

 

[MrRob]

Sweet!

 

[Cookee]

With suspension like that i can't see how

I have a slightly more standard one and it tows the race boat very well - I think your race boat may be a little big for it though!

 

[peter unwin]

Towing vehicle? well yes & no

Hi,

yes - the suspension setup would actually be perfect for towing since it is pretty stiff and the dampers are adjustable. But the twin plate racing clutch requires that you rev it , dump it and go! so it would not suit a towing at all as shunting around would be virtually impossible.

The original clutch it came with is the largest single plate road clutch you can fit , but even that won't handle 900Nm torque. I suppose you could fit a new one of these and then remap the engine management to limit the torque output to < 700Nm . . .

Regards Peter

 

[mercman13]

Towing.....

There would be hundreds ( thousands ) used for towing over here in Australia.....even the V6 models are awsome to tow with.