Trim tabs

[Lars T]

Is anyone runing these automatic adjustable trim tabs - SmartTabs??

worth a go or simply crap...

http://www.nauticusinc.com/index_1024.html

 

[BluFin]

Looking at them I would suspect a 21' Phantom pushed hard would break em!
Its a charged nitrogen gas strut, top up/servicing you would need a HP Nitrogen source & regulator & charging Kit. see if those are available in your area first . A regulator & small bottle in the UK is about £300.00 you would still need a charging adapter/ Kit

 

[Lars T]

Not worth the hassle i guess

 

[streamlined propellers]

smarttabs

we have been selling smarttabs for 18 months and have yet to see a strut fail cost incidentally is £120.00 + vat for a set of tabs. recharging is not an option, the struts are available should you manage to break one or want to upgrade to higher poundage

 

[jw.]

From a person who has them, I've been told they work well on a smallish boat but, apparently, you have to gun it in a following sea to get the bow up. No personal experience of them.

 

[streamlined propellers]

ref. following sea problem, this could be due to incorrect adjustment of the cam on the tabplate presure reduction may help

 

[BluFin]

Streamline did you used to be in Ash about 15- 20 years ago?

 

[streamlined propellers]

gues what ,i still am

 

[Matt]

I spoke to you a couple of years ago - just after you'd had all your props stolen I think. Did you ever manage to recover any of them?

 

[BluFin]

gues what ,i still am

eek! small world you used to do the props for the old boy & myself yonks ago.

Can we rename the site to OldBoatmadbuggersthatarestillaliveandresurfaceandchatonline.com

 

[nick ward]

trim tabs

Have keikhaffer tabs on P23 with 300 promax - tabs have stopped functioning. Fuse blown - replaced fuse and just blows again.
Each tab has its own switch and its own pump - where's best place to start to identify fault ?

 

[Burty]

disconnect battery and using a conninuity tester start at the switches and work your way back.

 

[nick ward]

many thanks

 

[Jon Fuller]

I would think you have a seized motor.

Are they 110S's (motor/pump mounted directly on the transom/tab, inside boat) or do they have flexi hoses to the pumps?

 

[JamesM]

A continutity tester will only work if you disconect the motor and solenoids and buzz the loom and switches out seperatly. If you dont you will see the winding resistances of the motor and solenoids and may well become confused.

 

[nick ward]

Thanks, will look more closely at motor type this w/end. Motors are mounted inside on transom directly above tabs.
Can motors be re-wound cost effectively ?

 

[Burty]

Thanks, will look more closely at motor type this w/end. Motors are mounted inside on transom directly above tabs.
Can motors be re-wound cost effectively ?

Anything can be re wound, but these days it seems to be cheaper just to buy a new motor

 

[nick ward]

OK
Checked out actual units this w/e.
No hydraulic pipes on these - pump & motor located inside of transom directly behind tabs -
Written on motor -
Keikaefer Brunswick marine - Hi Performance-Wisconsin
Serial No 68585
12v DC
SAEJ 1171 Marine
10-30 or 10-40 motor oil

Nothing else written on them.

Boat has only 110 hrs use in 5 yrs and tabs will hardly have been used - is that the problem or should this higher quality system be ok with such little use.
Any suggestions for cheap source ?

I removed blown 20 amp fuse for these tabs and havent replaced it yet - noticed battery was struggling to turn over engine although starts immediately - is that connected to removal of fuse ?

Rgds
Nick ward

 

[Burty]

shouldnt be, your starter motor could be getting tired

 

[nick ward]

Any suggestions as to a good cheap source if I need to replace the starter ?
Will engine serial no. identify starter or may there be one of several options for any serial no ?