4" exhaust hose

[mamboking]

Can anyone tell me where I can buy some 4" rubber exhaust hose? anywhere near Southampton would be great.

[neal_skyline]

hampshire hose,not far from drivers,i do have sum but only 40cm long

[mamboking]

Cheers Neil, I have been in touch with them, just the job! I am fitting some Rex Marine diverters. I dont know how much I need until I get the parts.

[Tony Davis]

couple of foot would do. Or buy Imco, as they come with the hose!

[mamboking]

Cheers Tony but I got a cracking deal on the diverters, $250 for some new old stock; I will take the hit on the hose! I know I only need a short length to cut into bits, any advice on cutting it up? I understand its a pain due to the wire imbedded.

[Downhilldai]

The hose suppliers will have a nice big chop saw that slices cleanly through it. If you know the sizes, they should be able to cut it for you. Otherwise it's a hacksaw job and wire cutters for the reinforcement.

[PerformanceDodge]

You can buy 1mm thick cutting disks for a 4 1/2 inch angle grinder, will make a bit of smoke with the rubber but they cut stainless like butter and make a realy neat cut. Made by Wurth Automotive, Dronco or most tool suppliers will get hold of them. If you get stuck PM me your address and will stick a couple in the post.

Regards David

[mamboking]

cheers guys and your suggestion David but I dont have an angle grinder. The way forward will be to find a supplier who is prepared to cut the pieces nice and neat and to size.

[neal_skyline]

got a cutter u can borrow with 1m blade in it