Stand off bracket design

[Dan]

Originally Posted by Sam1cats

I have then made if any use to you I will post a picture of one of mine they are not cheap to have made there is nearly £1000 worth of materials in marine grade Alloy they are 15 mil thick front and back and 10 mil top bottom and five bulkheads these are a bathing platform as well and powder catered you could easily put 600 hp on it but keep in mind they are quite heavy but can be made In Finer material but will take less horsepower you need to use 5083 marine grade Alloy otherwise they will crack

Ouch a grand on 5083, you must be using 4 sheets per bracket?

[Sam1cats]

Hi not sure how many sheets as I just pick it up from the waterjet company all done ready to Weld but there is quite a lot the pod is 7 foot wide two people can just about left it off the floor

[Dan]

Originally Posted by Sam1cats

Hi not sure how many sheets as I just pick it up from the waterjet company all done ready to Weld but there is quite a lot the pod is 7 foot wide two people can just about left it off the floor

That's fair enough I was just curious as I run a waterjet company and sheets of 5083 are cheap at the moment.

[Sam1cats]

How much could you do two sheets of 5083 10 mm delivered to Bournemouth