Forum: Gallery
23-02-2011, 09:06 AM
|
|
Replies: 43
Views: 9,844
Yeh its deffinatly a but highly strung going to...
Yeh its deffinatly a but highly strung going to keep pushing the engine this year and hopefully get the performance i,m looking for if not I will sell both motors and rebuild a t50 cammer i have came...
|
|
Forum: Gallery
22-02-2011, 11:08 PM
|
|
Replies: 43
Views: 9,844
strip down
Motors out and apart and not in bad condition, pistons and rings are shot but the rest is fine slight bore wear at the top of the bore,s but that,s it .
Other parts not so good the intercooler had...
|
|
Forum: Gallery
21-01-2011, 03:47 PM
|
|
Replies: 43
Views: 9,844
|
|
Forum: Gallery
21-01-2011, 08:20 AM
|
|
Replies: 43
Views: 9,844
|
|
Forum: Gallery
21-01-2011, 08:17 AM
|
|
Replies: 43
Views: 9,844
|
|
Forum: Gallery
20-01-2011, 10:21 AM
|
|
Replies: 43
Views: 9,844
Refresh
Started to pull the motor from the rib last week, the couple of overheats the engine sufferd last year during testing took there toll on the engine compresion and made it a bit laggy on boosting up,...
|
|
Forum: Gallery
27-07-2010, 11:32 AM
|
|
Replies: 43
Views: 9,844
Prop
Prop is now 13x19 3blade cleaver with 1.51:1 ratio box.
|
|
Forum: Gallery
26-07-2010, 09:30 PM
|
|
Replies: 43
Views: 9,844
Low,s and High,s
Have had a suspicion that the previous raw water cooling problems might have caused a problem with the engine as it started blowing a bit of coolant out the header tank when boosting over 12psi, so...
|
|
Forum: Gallery
15-05-2010, 10:20 PM
|
|
Replies: 43
Views: 9,844
problems
The volvo e drive leg has no water pick so i connected the intake to the sea water filter to the scoop feed of the secondary heat exchanger thinking this was the best solution, it was until you go...
|
|
Forum: Gallery
06-05-2010, 02:08 PM
|
|
Replies: 43
Views: 9,844
pics
Some pictures of outboard steering system adapted to fit
electrical side of engine with seawater pump for chargecooler-first stage engine heatexchanger and turbo/exhaust cooling. Second stage...
|
|
Forum: Gallery
03-05-2010, 10:51 PM
|
|
Replies: 43
Views: 9,844
Engine/Drive
Thanks for your input
Done a lot of work with these cosworth engines in the past and know they can make good power.I thought the v8/bravo setup is a bit to heavy for this size boat and didnt fancy...
|
|
Forum: Gallery
30-04-2010, 07:45 PM
|
|
Replies: 43
Views: 9,844
|
|
Forum: Gallery
30-04-2010, 06:24 PM
|
|
Replies: 43
Views: 9,844
testing
done some mods over the winter moved the engine gauges into rear of cockpit and gps into the front ,was having a bit of trouble keeping a close eye on the gauges and the water at the same time....
|
|
Forum: Gallery
15-06-2009, 06:14 PM
|
|
Replies: 43
Views: 9,844
Bling
Hoping they will distract eyes away from the slightly rough looking rib going on it.
|
|
Forum: Gallery
13-06-2009, 11:52 AM
|
|
Replies: 43
Views: 9,844
|
|
Forum: Gallery
13-06-2009, 12:53 AM
|
|
Replies: 43
Views: 9,844
|
|
Forum: Gallery
13-06-2009, 12:24 AM
|
|
Replies: 43
Views: 9,844
pics
trailer pics should have put these in last post oops
|
|
Forum: Gallery
13-06-2009, 12:12 AM
|
|
Replies: 43
Views: 9,844
new trailer
trailers on its wheels at last, still got one more axle to fit and bunks to go on
once i decide the best position for them.:up:
|
|
Forum: Gallery
10-06-2009, 09:52 PM
|
|
Replies: 43
Views: 9,844
bit by bit
Its been slow progress last couple of weeks had a lot of other stuff to get done but the galvanized nuts/bolts for the trailer turned up today 1 week late and 6 m16 nuts short (thanks techfast they...
|
|
Forum: Gallery
29-05-2009, 03:50 PM
|
|
Replies: 43
Views: 9,844
I,m sure they were the same as 4x4 but had a...
I,m sure they were the same as 4x4 but had a blank for fitting water injection nozle. late ecu also has baby board ready to run w/inj with correct software.
my intercooler has been jacketed with...
|
|
Forum: Gallery
29-05-2009, 01:43 PM
|
|
Replies: 43
Views: 9,844
|
|
Forum: Gallery
29-05-2009, 09:09 AM
|
|
Replies: 43
Views: 9,844
galv
it cost 210 its new steel so didnt need blasting b4 dipping
they go by weight in then weight out for cost
make sure you drill all sections of box top and bottom both ends so it fill,s and drains...
|
|
Forum: Gallery
28-05-2009, 11:48 PM
|
|
Replies: 43
Views: 9,844
pics
current drive leg
trailer back from galv
|
|
Forum: Gallery
28-05-2009, 01:56 PM
|
|
Replies: 43
Views: 9,844
it runs
added some fuel last night
fitted battery,s and she fired up first hit had good idle and all seems ok
got some wiring to tidy some gauges to move.
waiting on modified hubs for trailer axle,s so...
|
|
Forum: Gallery
27-05-2009, 02:32 PM
|
|
Replies: 43
Views: 9,844
Yb
The turbo is a modified garrett t3 has larger 360 thrust bearing, inkonel turbine wheel/shaft and wastegate to take the heat and the water cooling is now raw water through 1/2 steam hose.
it will...
|
